Enable Remote Access from WIFI AP Mode

Enable Remote Access from WIFI AP Mode

How to Enable Remote Access on AcuLink 810 via WIFI AP Mode


The following document provides users with a procedure on how to enable remote access on the AcuLink 810 using the WIFI Access Point broadcasting from the gateway.  This procedure uses a laptop to connect to the WIFI network, however the same can be done using a smartphone.

  1. Using a smartphone or laptop, check for available WIFI networks.  The AcuLink 810 WIFI network will have the following SSID:

“AcuLink810-WIFI-S8Pxxxxxxxx”

Graphical user interface, applicationDescription automatically generated

 

















  1. Once the network is discovered, click on it to join.  The password for the network is accuenergy.









  1. After connecting to the network successful, the network should say “No Internet, secured” as per the image below.









  1. Next open an internet browser (Google Chrome/Firefox recommended).  Enter the following IP address:

192.168.100.1




  1. The following web page will be observed saying the “Connection is not private”.













  1. Click on the “Advanced” button and then select “Proceed to 192.168.100.1 (unsafe)”.






























  1. Next you will be redirected to the following login page.













  1. The username and password to access the web interface is admin/admin.
















  1. The following dashboard will be seen.










  1. To enable remote access, click on the “System Settings” tab and select “Remote Access”.
















11. Enable “Remote Access” and click on “Save”. 

















  1. After the setting is saved, click on “Manual Register”. 





















  1. After the registration the status will be offline, click on the “Refresh Status” button.






















  1. The status will change to online, and the remote access URL will be available. 















  1. Use the remote access URL to access the meter remotely.


Graphical user interface, text, application, emailDescription automatically generated












    • Related Articles

    • Tenant Access

      AcuCloud – Tenant Access The following document explains how to navigate around AcuCloud using the Tenant Access. The Tenant access provides users with only data and billing information related to a specific billing metering point. Inviting Tenant to ...

    • Data Log Configuration using meters internal memory on Acuview

      AcuDC 240 - Data Log Configuration using meters internal memory on Acuview This document provides a procedure on how to configure the data log on the AcuDC 240 series meters as well as how to read the data from the data log once configured. You will ...

    • How to download Trendlog Managment data

      How to download meters data using Trend log Management The Trend log management allows users to access the meter data directly from the data base of the Acuvim II. This acts a back logger for users if they need to access the meter data or if they ...

    • Shunt Configuration

      AcuDC 240 Series - Shunt Configuration The following document shows users how to configure the shunt related settings from the meters display. When using a shunt with the AcuDC 240 series meter, the circuit must be broken to install the shunt in ...

    • Change CT Direction from Meter Settings 1312

      AcuRev 1310 – Changing the CT Direction from the Meter Settings This document provides users with a walkthrough on how to change the direction of the CT through the meters settings. This setting change is performed from the AcuRev 1310 series meter ...